left side seat deployment squib 1 circuit open ram

(3)Disconnect the negative battery terminal. (2)After erasing the diagnosis code memory, check the diagnosis code again. (1)Connect the negative battery terminal. Check whether the diagnosis code is reset. Repair the CAN bus line (Refer to GROUP 54C - Troubleshooting ).

Use M.U.T.-III to diagnose the CAN bus lines. Open circuit to side-airbag module (squib) circuit.The code is set when the open circuit occurs to the SRS-ECU side-airbag module (squib) circuit. In case of side collision, when the impact exceeding the threshold is applied to the vehicle, and when the impact is simultaneously detected (turned ON) by the side impact sensor as well as by the analogue G-sensor in SRS-ECU, the electric current is supplied from SRS-ECU to the side-airbag module (squib) of impacted side. If the diagnosis code B1C29 is set to SRS-ECU, be sure to diagnose the CAN bus line. The right seat airbag then needs to be replaced.Code No.B1C29 Left side-airbag module (squib) system (open circuit of squib circuit) Code No.B1C29 Left side-airbag module (squib) system (open circuit of squib circuit) That proves the wires are good from the module to the airbag connector. The connector at the airbag could be shorted, so see if the shorted code is still set. If a shorted code now sets, the wires are good between the module and that connector.ģ. If the connector is OK, short the wires together and clear codes. There are two wires, one is Violet/Light Blue and the other is Grey/Light Green.Ģ. Check the connector under the right front seat. After unplugging and replugging in connectors clearing codes and removing all debris from underneath the seats airbag light stay off.ġ. But both seats had degree underneath them which may have caused the wires to get tugged on setting Vault airbag codes. And both the drivers and passenger side seat airbag seem to be connected well. Able to access the connectors under the drivers and the passenger seat to check to make sure there was a good connection there. Or what I would actually be called is the driver squib circuit active and passenger squib circuit active. This Chrysler 200 had an airbag light on what code stored for both are a passenger and the driver’s seat airbag.

Left side seat deployment squib 1 circuit open ram